New Zealand Datsun Club

Hey mate.

Sorry for super late reply, datsuns been on the back burner for awhile. I’m still keen to take the hubs off you if there still available! Don’t worry about measuring them I’m sure they will work lol

I’m in Nelson so will need to be courier down if that works for you?

Cheers

Sweet mate looks good!
Where abouts are you? I'm really only after the hubs.... is it all good for you to strip them off the struts for me?

Vlturbo wrote:

jmp wrote:Bump! Still after these if someone has any?

I might have some in the shed, I'll check once I've had a clean out tomorrow


Sent from my iPhone using Tapatalk

Thanks man any luck in your shed?
Who would of thought these would be that hard to find!

Bump! Still after these if someone has any?

As above, I am doing the s13 brake upgrade but have found my disk brake front end hubs are widening the track too much and are causing fitment issues for my rims. The drum brake hubs are apparently 10mm thinner so i will try that before i look at different offset rims. I am happy to take a full set ...

Cheers for the replies guys After a bit more research looks like this was indeed a factory nissan unit as it has less clutch plates and a thick spring washer. Aftermarket units like nismo has almost double the clutch plates and the 'spring pressure' is supplied from 4 clutch plates which are dished ...

Here is some pictures of the new LSD I was going to fit to show the difference

Hey guys Was pulling a locked R200 out of a mates 260z to fit a newer lsd and found it already had a super tight lsd but it's a type Iv never seen before, anyone know how this type works? It has the standard clutch plate setup with a fairly thick dished Spring washer on each side of the spider gears...

I have king springs in my 1200 ute which I cut a coil off the top to get slamage. I just took my insert out and got an engineering shop to trim 2 inches off the top and rethread in a lathe think it cost me 50 bucks and passes warrants no problems

Hey guys

I'm after some 1200 ute bump stops that I can cut down for my ute.

Cheers