New Zealand Datsun Club

Since doing the cam gears was the big annoying project I’m not doing smaller annoying stuff that I don’t like. I got these bonnet catch’s from DJ and they have worked out really nice . I dragged the bumper back out from behind the shed and started to bond up the crack . This thing is in quite rough ...

In my last post DJ machined out the pockets on the cam gears for me which came out real nice. During this lockdown there was no better time to finish machining the cam gears and setup all the equipment to dial them in fully. i actually wrecked a set of oem gears ( the inner gets machined out and the...

Great work on the headers and frame rails.

I've got an R200 you can use, its complete though.

I believe BART has the empty " test fit housing"

Mocked up all this last night this engine does run but currently these parts are only sitting in place for a fit and form check , i need to order some gaskets and things. DJ Milled the cam gear pockets for me, so i can finish those in my lathe at home. Had to weld up and re mill a bore on the fuel r...

Great to hear from you, by all means my Z has taken me far too long and still isn't back on the road. But thats ok because the journey of learning and figuring things out was able to get me out of the office and working on cars for a living, so i could say the 12ish years ive had mine was actually q...

Got the inercooler welded
Designed and machined this RB fuel reg adaptor out of scraps i found
Welded some thread bosses on the cooler pipes to do proper clipping of fuel lines

Been ages since posting but ive done a few bits n pieces. bought a $300 mystery NA engine slapped my heads and cams in it and thats now running in the car along with the existing turbo and manifold setup. with more compression it should drive nicer and go a lot better. Inter cooler number #3 is a pr...

I will see you guys at the track day and possibly the dinner. I Will have the 100 series Cruiser there if we need to trailer anybody home.

I can also show you my desk since i work there.

A while Back i started working on this CAD design for a new higher flowing Plenum, got this far and sort of stalled out. Plenum Z31 LY1157 v11-2.png Plenum Z31 LY1157 v11.png The next 3 pictures is restoring some damaged, rusty hacked brackets to do with the face lift front end that i am fitting to ...