.

[dirtyleppa]

agree with adam, leave them as is.

wheels look epic. better than paying stupid money for someone else to do them. i might have to look into this tooo

[MR1200]

do it ya just gota take your time and cut straight and make sure they spin true its cost me 14 bucks so far but thats only for 2 of them

[dirtyleppa]

still, a bit of patience and some cutting discs is a lot cheaper that someone else doing them. did you check them for run out on a lathe or tyre machine?

[MR1200]

just a tyre balancer bud

[Josh]

Yeah Steelies!

[MR1200]

not a bad lookin shed!!!

[dirtyleppa]

twice as goood with 2 utes

[dattosan]

wowww nice mods .. thats was my dream engine lol.. r u using ga16de or ga16ds ??

whats r the mods need to be done ??

sry my english r not so good ..duh..

[z181200]

Paint the entire steel gloss black you can get some mean sparkly gloss blacks in cans. They will look pretty ruggard all rusty. Its not a rat rod. And its not dented enough to be motorfix

[MR1200]

yea havnt painted em yet cut them up again and made 10s. im just using them as templates so i can get the right offsets and sizes that way there will b no confusion wen i get my custom ones made

wowww nice mods .. thats was my dream engine lol.. r u using ga16de or ga16ds ??

whats r the mods need to be done ??

sry my english r not so good ..duh..

and heaps of little ones the main ones are the gearbox holes lining up and making a fly wheel but there to many to list