WTB or Swap Input shafts

[Datto_610]

Hey i currently have a pair of 5x1 stud pattern input shafts for a R200 VLSD but i need the 3x2 pattern ones for my project, have already got my cv axles greased and assembled so dont want to just change them all to 5x1, can do a swap or just buy some im not too worried. In chch would be preferred but understand it might be difficult at the moment no rush either. Must be for a Viscous LSD so one shaft should be longer than the other. Cheers.

[Datto_610]

Bump heres a better idea of what im after minus the LSD center.

[Bartman]

would you like me to try at silviaNZ greg?

[Datto_610]

Already have and they are telling me that 3x2 ones wont fit?????

[Bartman]

Would you like to bring your LSD center over and try one of my 3x2 inputs in it?

[Datto_610]

Yeah dude sounds good, quite keen to prove these guys wrong.

[unlimitedpower]

Weird i thought that they were interchangeable.

[Bartman]

I fitted 3X2 non lsd inputs into an R31 open center, which had originally used those intergrated input cvs.

[unlimitedpower]

I honestly thought that the only difference between the 2x3 and the 5x1 was the Hole location.
Id be very interested if someone could try this and prove otherwise.

[Bartman]

We'll know for sure when we try gregs in my diff.