A series extractors

[2 doors]

you could, but it would change the angle of the exhaust, it would have to be heated in 2 places and bent down about half way down the headers then bent back up at the collector, to allow a parallel run for the exhaust

[Tony_Whenua]

Im currently planning on putting my worked sedan engine in the ute so will have a sedan cross-member. So in that case im guessing that it aint going to fit.

yeah, you would be correct in thinking that, sounds like a pretty cool set up though, we going to see some pics?

Heading home in May and hoping to get Chris_g1 to give me a hand with the transplant. Will take plenty of pics then as we all know

[damz721]

Should fit an a15 in a b210 wagon no worries eh?

if so very keen on pics

[2 doors]

will take pics tomorrow, yes they should fit your 210

[damz721]

manage to get them pal?

[Tony_Whenua]

Ive just paid for them to come to Blenheim. Im going to try them on my sedan but if they aren't what Im after you are more than welcome to try them on your wagon bud!

[damz721]

sweet as

[2 doors]

sorted the issue regarding fitting to a 1200, cut the exhaust where it attached at the collector ,as I didn't look properly the first time, I hadn't picked up on the fact that these were on a rally car and the exhaust portion had been welded on the piss to tuck as close to the floor as possible, currently they are on there way to Blenheim where tony will try them on his ute,

complete dumb shit moment there, didn't read the whole page through