Hi guys anyone know how to remove this piece of chrome moulding from a 330 260C?
I've got the rest of that section off and taken the single screw out holding it but it won't come off and I don't want to force it until I know how it comes off.
This bit here, it's the rear part of the trim that goes over the doors and is attached to the body.
Cheers
Chrome trim removal question - 260C
Re: Chrome trim removal question - 260C
I use a wide bit of wood sit it in behind the chrome and soft hits of a hammer onto the wood
So damage yet
So damage yet
"It's ok, we know what to do...we talked about this a lot on the internet."
Re: Chrome trim removal question - 260C
Turns out it has a couple bolts holding it on from the inside of the car.
Got it off now so all good
Got it off now so all good
- brocky41
- Financial Member
- Posts: 1764
- Joined: Sat Jul 19, 2008 11:05 am
- aka: Brocky
- Location: Christchurch
- Contact:
Re: Chrome trim removal question - 260C
Yip was just about to say the two bolts from the inside - you have to remove the rear "c" piller cover to get to them.
If you snapped them off i do have spares
If you snapped them off i do have spares
- brocky41
- Financial Member
- Posts: 1764
- Joined: Sat Jul 19, 2008 11:05 am
- aka: Brocky
- Location: Christchurch
- Contact:
Re: Chrome trim removal question - 260C
260Cs have pretty much everything bolted or screwed down - even the sill trims have hidden bolts holding the end caps on loltorqued wrote:I use a wide bit of wood sit it in behind the chrome and soft hits of a hammer onto the wood
So damage yet
- brocky41
- Financial Member
- Posts: 1764
- Joined: Sat Jul 19, 2008 11:05 am
- aka: Brocky
- Location: Christchurch
- Contact:
Re: Chrome trim removal question - 260C
Is this beast getting some paint??kicker wrote:Turns out it has a couple bolts holding it on from the inside of the car.
Got it off now so all good
Re: Chrome trim removal question - 260C
Na no paint just yet, was investigating a little bit of rust.
I might grab a replacement off you though, I got it off safe then managed to break the plastic cap on the bottom edge haha
Actually there's a few things I'm looking for now, I'll send ya a PM
I might grab a replacement off you though, I got it off safe then managed to break the plastic cap on the bottom edge haha
Actually there's a few things I'm looking for now, I'll send ya a PM