A15 parts needed

[nzdatman]

After an A15 crankshaft and front pulley, or possibly complete short or long block, condition and price dependent.
What have you got?

[Bartman]

I have a brand new custom front pulley. Two piece item. A little pit heavier than the stock ones. But it wont split the way that the factory cast ones do.

[taiparacer]

who do u want to call

[nzdatman]

Bart, have you got a pic or some info on that pulley Bart? Is an under driving one?
Am now considering making one a bit smaller than standard.
Mine has split through the keyway.

Ron, thanks, will give you a ring when I figure out exactly what I'm going to do.

[Bartman]

I'll try get you some pics.
it's just a standard diameter pulley. but as it's two piece, you can easily make a smaller pulley to attach to the center hub if needed.
the factory pulleys are one of the few (only three to my knowledge) faults in the A series design.

[Bartman]

I just sent four photo's to the addy on your profile Morgan.

Let me know by txt if you'd lke more pics. (ie, of the two halves separated)

[nzdatman]

That's a nice looking pulley Bart. Is the outer part aluminium and the inner steel? I'll keep it in mind but at this stage I'm leaning towards making a new one piece steel pulley in a smaller diameter. Your one looks like it would have limited scope for reducing the diameter?

[Bartman]

Yeah, aluminuim and steel.
I've not thought about under driving one.
I had them made for street application.