I'm Back and this time it's getting finished

[MONTY]

ahoy hoy all, long time no see after ten years i've finally put aside a few g to finish her off and finally enjoy all the work i've put in but i need to pull in all the help i can get whether it just be advice or maybe you got a hook up somewhere I am on a limited budget but i rekon its do able.

so i need to have a few convo's about the following

rear suspension, subframes toe angles etc
draglink modifications and sway bars
coill over conversions etc
cert and cert process
who can do seat mounts

and need to start sourcing
180b rear seat (ideally)
speedo drive
oil cooler sandwhich kit
gear stick boot
short shift kit (s14 gearbox)
fuel pumps

i know there are topics that i'll post individual subjects on but i really just wanted to say i'm back and shits getting done!!

and i've even set a deadline of 2-3 months

[Bartman]

Welcome back Lee!
I can recall a very long time ago you posting a savage garage burnout.
So its long overdue to see this machine completed.

[maddat1]

I have rear seats n 3 x door cards for p610 and iam in auck.

[Datto_610]

Good shit man! I'd recommend going adjustable rear subframe like I have your welcome to have a squizz anytime.

[MONTY]

thanks bart good to see you still on here! Gregg good to see you still here too and i'm keen to come check your subframe out! i'll check out your rides post first, did it cost you much? and thanks for the offer about the seat dude problem is i've got an 810 i got a 610 back seat of chris but they don't fit.

[Datto_610]

No worries! Didn't cost that much actually I should have all the files to make all the bits needed the hardest part is cutting out the old control arm mounts but is so worth it!