Page 2 of 2
Re: conversion parts needed for b310 sunny.
Posted: Tue Jun 05, 2012 10:21 pm
by brocky41
Loving that many can help a little bit to get the job done - what a clubs all about - many thanks guys
Re: conversion parts needed for b310 sunny.
Posted: Fri Jun 08, 2012 2:19 pm
by Blair
Just let me know which drive shaft you need.
Cost $100 for all the bits. Plus freight.
There is a good amount of meat on the clutch, no burn marks on the flywheel or the pressure plate.
Re: conversion parts needed for b310 sunny.
Posted: Fri Jun 08, 2012 7:23 pm
by crustywhip
Have you tried Tony (flauski) he has wrecked a few of these so no doubt will have some thing to add.
Re: conversion parts needed for b310 sunny.
Posted: Sat Aug 04, 2012 4:09 pm
by brocky41
Hi guys thanks to all that are helping with this,
I still need A12 4 speed Gear stick (any shape bent or straight) and a 1200 Clutch Cable with the small end and small bit that stops inside the gearbox bell-housing. (basically B110 one)
Cheers Brock
Re: conversion parts needed for b310 sunny.
Posted: Sat Aug 04, 2012 8:27 pm
by 2 doors
damn i have 2 clutch cables you could have, but they are in storage, and under a heap of other crap, if i was in town id dig them out for you.
Re: conversion parts needed for b310 sunny.
Posted: Thu Aug 16, 2012 9:46 pm
by EMs SR1200 UTE
brocky41 wrote:Hi guys thanks to all that are helping with this,
I still need A12 4 speed Gear stick (any shape bent or straight) and a 1200 Clutch Cable with the small end and small bit that stops inside the gearbox bell-housing. (basically B110 one)
Cheers Brock
Hey, I was scratching around in my ute parts the other day and I found a clutch cable.
Make an offer and I will get it sent to you if you still need one.
I can look for a gearstick aswell as when we sold the original engine and box im sure the gearstick didnt go with it.