Page 2 of 2
Re: 3 or 4mm Aluminium Plate
Posted: Sun Aug 05, 2012 10:44 am
by nick_m
you will want to make them the same size as the turbo inlet greg. Thay will give you the best result. You can get silicon joiners to go from 2" to 2.5" to match your intake
Re: 3 or 4mm Aluminium Plate
Posted: Mon Aug 06, 2012 9:43 pm
by Datto_610
Dang really. Was hoping to make use of the bits of 2.5'' I had. What if I were to get some 2'' o,d pipe and just flare the end out 2.5'' like the factory cast one just that its pointing straight???
Re: 3 or 4mm Aluminium Plate
Posted: Tue Aug 07, 2012 5:48 am
by unlimitedpower
I had forgotten about this other wise i would have chopped off a chunk last night.
I'll try remember to do it tonight.