Page 2 of 2
Re: 620 ute door hinge
Posted: Sun Oct 06, 2013 7:21 pm
by Garth
Yeah I think my brother has already been raiding that as he lives in Timaz and has the 620
Re: 620 ute door hinge
Posted: Sun Oct 06, 2013 7:27 pm
by ThreeBlindNinjas
It's mostly all still there. Some external engine are bits gone, and maybe the front indicators. J15 engine.
Re: 620 ute door hinge
Posted: Sun Oct 06, 2013 9:18 pm
by Bartman
How rusty is the radiator support panel, and inner guards? I have a real sweet ute with frontal damage to the rad support and inner guards.
Re: 620 ute door hinge
Posted: Sun Oct 06, 2013 9:33 pm
by ThreeBlindNinjas
I'll have a look tomorrow, but if it's anything like the outside panels, it'll be shot. I'll snap a photo.
Re: 620 ute door hinge
Posted: Mon Oct 07, 2013 8:05 pm
by Bartman
Thanks!
Re: 620 ute door hinge
Posted: Mon Oct 07, 2013 8:13 pm
by ThreeBlindNinjas
Re: 620 ute door hinge
Posted: Mon Oct 07, 2013 8:50 pm
by Bartman
Can you see any rust down in the bottom of the rad support panel?
How much for the inner guards and rad support? I'd be prepared to cut them off myself. (to get the right parts undamaged)
Re: 620 ute door hinge
Posted: Mon Oct 07, 2013 8:56 pm
by ThreeBlindNinjas
I'll have a good look at the bottom of the panel for you. I can get the panels off un-damaged!
That's sort of my job...
I'll get a price, and yeah... there is the possibility that you could get them off yourself.
Re: 620 ute door hinge
Posted: Mon Oct 07, 2013 9:36 pm
by Bartman
Ideally it'd have part of the firewall cut out. Then I can unpick the spot welds on the ground so as to not get any holes in the tabs which will be rewelded to my cab.