New Zealand Datsun Club

85_Z31 wrote: Just use spacers and do skids.

Fixed!

bart you got some spacers .....

ideally what i need is 12x1.25 thread with 13mm shank then it will jus bolt together i dont know what the gtr has but was thinking just gettin gtr bolts and tappen crown wheel to suit if the gtr has bigger thread that is ?

Do the GTR run an R200 or an R230?
I had thought they were bigger.

THE R32 GTR LSD CARRIER I GOT FITS INTO MY R200 SO I GUESS THAT EQUALS R200

510BRE wrote: ideally what i need is 12x1.25 thread with 13mm shank then it will jus bolt together i dont know what the gtr has but was thinking just gettin gtr bolts and tappen crown wheel to suit if the gtr has bigger thread that is ?

what length do you need? Let me know I might be able to source you some bolts like that.
you won't drill and tap the crownwheel without some pretty fancy tooling. the gears will be case hardened.

TRUE FORGOT ABOUT HARDNING MORGAN THE BOLTS ARE 22 MM UNDER THE HEAD OFF THE BOLT

how much shank and how much thread

8.5 SHANK AND 13.5 THREAD

just realised the bolts you need are metric fine I think the shoulder bolts we get are standard pitch. will check it out on Monday for you. otherwise I'll spin up some spacers for you.

THE SHANK THICKNESS I HAVE IS 11.90 AND NEED TO FIT INTO 13 MM HOLE.... YEAH MY BOLTS 12mm 1.25
MATE MORGAN THAT BE MEAN IF YOU COULD DO SOME SPACERS FOR ME