Re: 310 or 1200 ute steering bits
Posted: Fri Sep 25, 2015 8:14 am
whats so good about putting these "bigger" ones on ya b110?????????? to me it seems abit of a waste as you will spend 300-400 on just b310 parts
Good point. I was under the impression the 310 ball joints were stronger and gave negative camber off the bat meaning less camber needed on the camber plate. Also the castor rods would provide more adjustment than the 110 rods?
If this is a whole lot of bs then I'd much rather keep the original parts I already have painted and bushed ready for installation...