Re: Parts for H220 260c
Posted: Tue Nov 10, 2015 4:05 pm
WHAT AKAROA PHOTOS???
Page 2 of 2
Re: Parts for H220 260c
Posted: Tue Nov 10, 2015 4:08 pm
don't worry just found them
Posted: Tue Nov 10, 2015 4:33 pm
Haha, they're coming, already done quite a bit of work to it 
Sent from my LT26w using Tapatalk
Sent from my LT26w using Tapatalk
Re: Parts for H220 260c
Posted: Wed Nov 11, 2015 7:15 am
Also looking at getting modified bump stops made if anyone else wants any 
Re: Parts for H220 260c
Posted: Wed Nov 11, 2015 10:54 am
I just cut mine down and rounded them off lol, you know what springs etc to use?
Posted: Wed Nov 11, 2015 12:37 pm
I've taken 1 coil out to stiffen slightly, will compress the rest.
Sent from my LT26w using Tapatalk
Sent from my LT26w using Tapatalk
Re: Parts for H220 260c
Posted: Wed Nov 11, 2015 9:20 pm
I found the super low 6 cylinder HQ holden fronts from either King or Cobra go straight in (have done a couple times now)
Lowers front by 60mm and use a 2 inch block in the back (or reset 2") and the sills sit perfectly even (tend to sit high in the front with factory coils.
Good time to throw in new shocks too - just use the HQ items again (shorter than original)
Lowers front by 60mm and use a 2 inch block in the back (or reset 2") and the sills sit perfectly even (tend to sit high in the front with factory coils.
Good time to throw in new shocks too - just use the HQ items again (shorter than original)
Re: Parts for H220 260c
Posted: Wed Nov 11, 2015 9:23 pm
Those bump stops hold your lower Ball joint in too - will you be making a whole new unit? Could be keenDattodevil wrote:Also looking at getting modified bump stops made if anyone else wants any
Re: Parts for H220 260c
Posted: Thu Nov 12, 2015 7:38 am
yeah, working out the best size to take them down to, probably around 25mm off standard.