New Zealand Datsun Club

Posted: **Wed Jun 15, 2016 8:46 pm**

Shorter rods, or shorter pistons?

Posted: **Thu Jun 16, 2016 8:18 pm**

Bartman wrote:Shorter rods, or shorter pistons?

5 mm longer rods and 10mm less pin height.

Posted: **Fri Jun 17, 2016 2:36 pm**

Nice.
what were the rods from?
Or are they custom jobbies?

Posted: **Fri Jun 17, 2016 4:43 pm**

Bartman wrote:Nice.
what were the rods from?
Or are they custom jobbies?

Saenz custom made.

Posted: **Fri Jun 17, 2016 11:05 pm**

Any idea how much they weigh?

Posted: **Sat Jun 18, 2016 2:43 pm**

Bartman wrote:Any idea how much they weigh?

507 grams .

Posted: **Sat Jun 18, 2016 5:31 pm**

Very reasonable.

Posted: **Fri Jun 24, 2016 10:42 am**

Sounds like a weapon have you had it on the dyno? got any torque and hp figures

Posted: **Fri Jun 24, 2016 7:27 pm**

Naki-Fisher wrote:Sounds like a weapon have you had it on the dyno? got any torque and hp figures

This setup is normally around the 175 HP.You can get more but reliability is not so good you want it to last more than a session.

Got this out from under the covers.