New Zealand Datsun Club

We (@ Firestone) do wheel nuts up with rattle guns - but with tourquing (talk ing) sockets that only go to 80 FP and then tourque to 90fp with tourque wrench.

That sucks arse dude at least it didnt come off aye

brocky41 wrote:we do wheel nuts up with rattle guns - but with tourquing (talk ing) sockets that only go to 80 FP and then tourque to 90fp with tourque wrench.

That sucks arse dude at least it didnt come off aye

Well when I took it there they snapped one, didnt even tell me before I left the shop that one was snapped, drove to Barts and he spotted it. So I got it replaced (thats the one that is still holding on) then the other 3 decided to let go (musta been fractured). Didnt have the problem before I went to Tonys... And I found that my Z where I had tyres put on by them also had loose valves (found out a few weeks ago when I got new tyres for it) so they leaked air! Moral of the story dont go to Tonys, ever.

brocky41 wrote:
That sucks arse dude at least it didnt come off aye

IT NEARLY DID
You should have seen the wheel wobbling Oh dear Matt was not happy

Man I would be going in there and absolutely tearing strips off them!

This is a Double Fail. Today outside the Champion flour mills on Moorhouse Ave, a truck and trailer drove out, but the Truckee hadn't connected the trailer up to the fifth wheel properly, and it promptly departed company with the cab blocking 2 lanes of traffic and leaving a huge gouge in the road. The Double fail is I took a picture of it on my mobile and it didn't work

LOL

DAMON how could you???

I know, and it didn't even get on the news, someone out there must have snappy snapped it.

I saw that truck.farking funny.big crane to lift it back on and everything.bugger