New Zealand Datsun Club

thats looking farking sweet

I just put another new set of rubbers in my sedan. I used this red sticky rubber contact adhesive that I got from Scotts old auto rubber in Oz, although I have F2 here I stuck to the red stuff. unfortunately I am not patient and would try to apply glue too much at a time, need to work just a couple of inches at a time I found out, I used about a roll of masking tape along the way too, to hold it in place, especially around the curved bits, as the rubber wanted to straighten out. the next day I just super glued all the bits that didnt take to the contact adhesive (I am rough...).

use silicon its sticks to everything thats what i used for my boot rubber

Today replaced plugs, points, leads, dist cap, coil and condensor. Dist was out 180Degrees. Emptied out old fuel and gave her some good stuff. Connected up radiator. Then Damon came round waved his magical wand and TADA its going way better. (Thanks Damon) Learnt alot about dellortos too, tricky wee things they are.

No problem, glad I could help.

good to hear, DO A SKID

DAMON FOR THE WIN

Damo's name should have been spelt with two "A"s. 'Cos he is Da-Man!

lol bart

all seals are on now and carpet is finished, just need air filters and exhaust needs extending because the new headers are shorter, then seats and dash to go back in and then wof time