Page 17 of 34

Re: Garth's SR20 B110

Posted: Wed Sep 18, 2013 8:54 pm
by mitey1200
Comment...

Re: Garth's SR20 B110

Posted: Wed Sep 18, 2013 8:56 pm
by Garth
mitey1200 wrote:Comment...
I'm glad you mention that actually. If you check out page 12 in my thread you'll see what I did to sort that problem

Re: Garth's SR20 B110

Posted: Wed Sep 18, 2013 8:57 pm
by mitey1200
Rodger that, on way

Re: Garth's SR20 B110

Posted: Wed Sep 18, 2013 9:17 pm
by Bartman
Where is this build up to Garth?
I lieu of me working on my cars, I need to enjoy updates on your build thread.....

Re: Garth's SR20 B110

Posted: Wed Sep 18, 2013 9:20 pm
by Garth
Getting my driveshaft hoop done tomorrow..then I just have to run my fuel lines and get some rust done in the rear Gaurds and she's ready to go!

Re: Garth's SR20 B110

Posted: Thu Sep 19, 2013 8:54 pm
by Bartman
Mail order WOF, and see you at Akaroa? :lol:

Re: Garth's SR20 B110

Posted: Thu Sep 19, 2013 9:04 pm
by Garth
Bartman wrote:Mail order WOF, and see you at Akaroa? :lol:
Haha something along those lines. Driveshaft hoop finished tonight so over the weekend my whole interior will be put back in and then I just need to run some new fuel line and the rust and she's good to go

Re: Garth's SR20 B110

Posted: Thu Sep 19, 2013 11:08 pm
by nick_m
Meeeeeean!!

Re: Garth's SR20 B110

Posted: Fri Sep 27, 2013 8:53 pm
by Garth
Welding folk I need your help! this is my fuel tank, the fitting in the second picture is the current outlet. I need this cut off and a fitting similar to the bent 90* pictured welded in its place. I do have another fuel tank I can cut a fitting off if that's easier then sourcing something different but I just need someone to do the welding?

fuel tank hasn't had fuel in it in over a month and was rinsed thoroughly with water after it was emptied.

this is one of the few things left on the to do list so help a brother out!

Re: Garth's SR20 B110

Posted: Fri Sep 27, 2013 9:33 pm
by Datto_610
Talk to nick!

Sent from my GT-I9300 using Tapatalk 2