Page 3 of 8
Re: SRDATO new non datsun project (still a Nissan)
Posted: Sun Apr 12, 2015 5:50 pm
by 85_Z31
SRDATO wrote:Snapchat--8595794143979808648.jpg
This arrived today. Along with a pair of 12" fans (over the shoulder with the viscouse) things should stay a little cooler.
looks like the same one i just bought. Redline one ?
Re: SRDATO new non datsun project (still a Nissan)
Posted: Sun Apr 12, 2015 6:31 pm
by SRDATO
I'm not sure. The company who does our radiators at work sourced it for me.
Re: SRDATO new non datsun project (still a Nissan)
Posted: Tue Apr 14, 2015 12:26 pm
by SRDATO
New snail arrived today, going single turbo for a multitude of reasons.
Should provide a good punch of tyre smoking power
20150414_110557.jpg
2015-04-14 17.57.57.jpg
Re: SRDATO new non datsun project (still a Nissan)
Posted: Fri Apr 17, 2015 1:34 pm
by SRDATO
It's like Christmas lots off goodies all ariving at once.
Just been to EPC and picked up some freshly coated parts.
20150417_131952.jpg
Tomie gears arrived.
20150417_111911.jpg
Re: SRDATO new non datsun project (still a Nissan)
Posted: Fri Apr 17, 2015 1:38 pm
by SRDATO
CP pistons and eagle rods
20150417_111221.jpg
20150417_111330.jpg
ARP head studs, bottom end studs and flywheel bolts
20150417_111811.jpg
Also a Tomei top end gasket kit and ACL race bearings arrived.
Re: SRDATO new non datsun project (still a Nissan)
Posted: Fri Apr 17, 2015 3:44 pm
by chris_g1
Christmas come early mate that turbos going to suck small animals for dinner watch your arm it will take that to bud.
Re: SRDATO new non datsun project (still a Nissan)
Posted: Fri Apr 17, 2015 4:16 pm
by SRDATO
Christmas used to be free when we were young, costs us an arm and leg these days
Re: SRDATO new non datsun project (still a Nissan)
Posted: Fri Apr 17, 2015 5:06 pm
by chris_g1
Hell yes but our toys are way better now aye
Re: SRDATO new non datsun project (still a Nissan)
Posted: Fri Apr 17, 2015 9:28 pm
by SRDATO
For sure
Re: SRDATO new non datsun project (still a Nissan)
Posted: Fri Apr 24, 2015 9:46 am
by SRDATO
Wee update, blocks under way getting stud kit fitted and bored out 1mm (40 thou) for the new pistons. Got the head back stripped and started porting and polishing it last night. Thought I'd have a go myself to save a few $$$.
Did my old dirt bike and wasn't too hard. taking 6 - 7mm out of each port and matching it with the manifold which I also need to port a little.
2015-04-24 09.25.37.jpg
Sinco manifold and 50mm Turbosmart gate arrived today also.
2015-04-24 09.24.49.jpg
2015-04-24 09.27.26.jpg