New Zealand Datsun Club

Zak_TheButcher wrote:I spose when you put it that it into that context your right.
Ive just been keep an eye out for one, but with a bit more to it. I have a few parts but its mainly suspension from doing my conversion.
I know that they are getting hard to find now, that why im trying to find one to do up to original standard.

I have a really good shell and lots of parts up here in auckland which I will sell for the right price, did have an FJ in it before it was panelled though so ma not be the very best for a return to stock project

Zak_TheButcher wrote:1600 shell

http://www.trademe.co.nz/motors/car-par ... 459023.htm" onclick="window.open(this.href);return false;

think hes asking for a bit to much for what it is???

That sellers auctions are always priced high. He buys cars and strips them out for parts @ max profit. He has a 210 skyline as I sold him the fender mirrors which I see are on.

http://www.trademe.co.nz/Browse/Listing ... =550748239" onclick="window.open(this.href);return false;

shit, maby i should up the insurance value on mine a bit

That looks soo mint, to recreate that would be impossible.I wouldn't be too proud to own it, although for the $$$ other cars would interest me more, looks a genuine survivor though. Hope it finds a loving home, at that money.

R200 LSD Clutch 2 way style.

This is the LOM59 style which is internally very similar to a NISMO GTR LSD

http://www.trademe.co.nz/motors/car-par ... 265403.htm" onclick="window.open(this.href);return false;

Incorrectly advertised so its not listed under R200

This has the Side gets with the correct spline count so you can run common 29 spline axles.

If you purchase a GTR 2 way is has 30 spline side axles.

Its not that cheap, but I paid around the same in second hand parts to build mine.

Are the parts to fix it available as he claims?
What would they cost?

New Clutch plates are available although they can be hard to find

the value in this unit is the fact is has 29 spline on the input

meaning you can use R31/Z31 cv ends to make a less complicated axle setup

$150 1200 shell

http://www.trademe.co.nz/Browse/Listing ... =553543337" onclick="window.open(this.href);return false;

datomic wrote:$150 1200 shell

http://www.trademe.co.nz/Browse/Listing ... =553543337" onclick="window.open(this.href);return false;

dam why does it have to be so far away

http://www.trademe.co.nz/motors/used-ca ... 316715.htm" onclick="window.open(this.href);return false;