Page 25 of 34

Re: Nick 1200 sedan

Posted: Mon Jan 09, 2012 12:50 pm
by dattoboy
Just go crazy nick haha. Looking good man, will pop around in a few days for a look.

Image

Re: Nick 1200 sedan

Posted: Mon Jan 09, 2012 1:11 pm
by classicdat
If you put stiffening bars forward or rearward of the suspension centrelines make sure they are not on your Cage Homologation Papers and are not seen as part of the cage. I have bars that go down through the chassis rail to the roll bar pick up points and track rod mounts on mine. Roll bar ones mount like the ones in Bede's picture to the strut tower, but are not tied into the cage directly. I see the lower bar going down in the engine bay, you may be able to make it all work, it is a good idea. I have another going back on a angle through the fire wall to the Dash bar from each side.
Just be cautious that all these bars will transmit all the impact energy into the cabin, decreasing crumple, this is good and bad.

Nick 1200 sedan

Posted: Mon Jan 09, 2012 4:46 pm
by kobyn
My setup


Sent from my iPhone touch using Tapatalk

Re: Nick 1200 sedan

Posted: Mon Jan 09, 2012 6:08 pm
by nick_m
Thanks Kobyn, I had a look at yours. My setup is probably as close. Its the width of the gas sheild on the mig torch from the body work so getting that last inch is a complete ass to do. But I guess I should probably just do it. It would probably bug me if I didnt.

Hey Vaugn, I wouldnt be able to come round and check out your race zed some time? If for nothing else than to have a bit of a lust. I dont think i have ever seen it. Is there a thread up here of it?

Re: Nick 1200 sedan

Posted: Mon Jan 09, 2012 8:20 pm
by classicdat
That would be fine Nick, I'm around this week, you don't have a gas plant and be able to Braise up my sump would you? I'm hoping the "Z Shed" will be a stop on the Garage tour on the 21st.

Re: Nick 1200 sedan

Posted: Mon Jan 09, 2012 9:10 pm
by nick_m
na sorry cant help there. Wal just lent me his TIG but I havent set it up and had a play yet so.
This arc eye is being a bit of an ass still so might use the opportunity to swing round for a geez. Can you pm me a contact number and ill swing round later this week and catch up

Re: Nick 1200 sedan

Posted: Tue Jan 17, 2012 10:11 pm
by nick_m
Sorry vaughn, ran out of time. My eye came right and I was straight out into the garage!

Roll cage is finished, I did two bars through to the strut towers in the end. Just sorting out the homologation and Log book for it at the moment. The nerves are high. I will feel much better once I get my bit of paper back saying my cage is legal!

Re: Nick 1200 sedan

Posted: Fri Feb 24, 2012 7:10 pm
by nick_m
YEAH BOI!!!
Image

Re: Nick 1200 sedan

Posted: Fri Feb 24, 2012 8:09 pm
by 2 doors
well done that man, you must deserve both a mallow puff and a db

Re: Nick 1200 sedan

Posted: Fri Feb 24, 2012 8:14 pm
by 85_Z31
Keeping it Safe nick :lol: well done.