New Zealand Datsun Club

If the crank doesn't need work done and its just a case of putting in new bearings, then I'm sure Bart could do that, if not then I could its not too difficult.
Plus its easy enough to send the crank to the engine conditioners if necessary

Sent from my GT-I9100 using Tapatalk

We'll see you right, give me a yell if you're having trouble getting someone to do it.
Vaughan

I think I might have some almost new standard shells that only did 500kms in a motor that died a death of 10000 screams. They aren't perfect, but they might be okay for a temporary patch up.

what does engine rev at @ 100KM? Have same rims, but no tyres yet........ would have thought with low profile a tad uncomfy? looking at a set of yokos at the moment and was just curious as it will be an open road car when it leaves the safety of a garage

So first drive in a year haha! and no more knocking! Turns out there was no locating washer in the pully or something like that so fucked all my bearings due to being unbalanced.
Ahh well shes fixed and in with a new loom that has resolved quite a few of my wiring issues
Going for a warrant on Wednesday, fingers crossed.
Damn forgot how stiff everything was after driving the silvia haha

Msdato wrote:So first drive in a year haha! and no more knocking! Turns out there was no locating washer in the pully or something like that so fucked all my bearings due to being unbalanced.
Ahh well shes fixed and in with a new loom that has resolved quite a few of my wiring issues
Going for a warrant on Wednesday, fingers crossed.
Damn forgot how stiff everything was after driving the silvia haha

you go girl, see you at akaroa with your new warrant