New Zealand Datsun Club

Your wagon is pretty awesome ! Need to see this sometime

have got this week off work, so far i have made the front springs(cuts) all captive using the standard oil filled shock and strategically placing a piece of 3/4 2wire hose out of my van to rangi- shorten the shock

have also pulled motor out of yellow sedan and going to put it in wagon later in week for a bit of summer fun






and i also pulled my round headlight bonnet to see if it would fit on square light model and it does, just leave's a gap above each headlight where the round headlight grill must be a bit bigger

Good work - the hose idea really works too....

wagon has gone from this



to this





i need to re paint rocker cover as lifting chains attacked it

How much harder does it go mate? I hope those bolts worked goodly for you.

now ive got something for my wagon to aim for haha!!

yea bart them bolts were sweet! and i used the nuts for engine mounts to, ill shout ya a beer at next cruise thanks for that mate

and haha yea it goes ok, need's the full exhaust tho, ill come over sometime n ya can drive it and see what u reckon mate

only drivers side guard away from round headlight conversion,anyone have one?