New Zealand Datsun Club

Bro rotors in datsuns are all g specally wif my flat peak hat on. I'm thinking about a monsta bridgey turb with race cut cam make it pulse hard. ill post up a pic tonight of the bodykit I found for it too

You absolutely MUST post your inspiration pic of that blue 1200 here.

Isnt she a beut

I think when you do a cyborg conversion you are meant to swap the turbo mitzi running gear not the headlights....

Man that is so criminal - and someone has worked hard to get it like that...

I hate what they did to that blue 1200.

Oh yea so do we. Some people have no idea . This probably would have been ok before they started on it haha.

Little bit of an update....

Engine out again - Thanks Earthquake - cross member in with s13 lower arms and 4 stud hubs. Got the coil overs in just had to lick up the 3 stud holes with the drill (larger stud) and they are in too.

The s13 arms are way to long - would be around 4 degrees neg camber and could only run high positive offset wheels ie +38 like the skyline wheels i used for a mock up, so next thing is to chop up, rose joint, make them fully adjustable and work out what to do for castor arms.






Tyre rubbing dude to no disks on hubs

hey brock apparently s12 bottom arms bolt up and are shorter (same ball joint taper) might mean 910 bottom arms bolt up too. Might save you chopping up the s13 arms. Are I believe its r30 castor rods you use with the s13 arms

Sweet thanks nick, yea its finding something that has the same taper but you got me thinking now.....