Page 39 of 125
Re: Datto_610's 180B Currently going back together
Posted: Wed Feb 13, 2013 9:47 pm
by broke
Looking very nice, I'm most impressed with those brakes and suspension. I look forward to copying this setup for my car and taking credit for all your hard work designing it hehehe.
Re: Datto_610's 180B Currently going back together
Posted: Wed Feb 13, 2013 9:52 pm
by Datto_610
Haha well I didnt design the brake conversion, got all that info off an Ozdat write up. As for suspension kind of just trial and error to see what works.
Re: Datto_610's 180B Currently going back together
Posted: Wed Feb 13, 2013 10:02 pm
by joelbrown
85_Z31 wrote:Another Wee update for Greg
he has Ordered Pads, and Rotors and they are on the way, Metric Fine Cap Screws have been ordered so once the rotors are machined that should tidy up front brakes!
caliper 3.png
caliper 2.png
Caliper.png
OZDat Style Brackets Thread Taped out to M12x1.25
and the koing B Bombs clear the caliper without grinding by a tits whisker
THOSE RIMS LOOK THE TITS! Are they shop bought as new? info pleeeese
Re: Datto_610's 180B Currently going back together
Posted: Wed Feb 13, 2013 10:10 pm
by Datto_610
Haha thanks man, I got them 2nd hand off trade me. Wasn't looking for these exact rims at the time but when they came up I couldnt resist.
Re: Datto_610's 180B Currently going back together
Posted: Thu Feb 14, 2013 6:58 pm
by 85_Z31
Crossmember is Back Greg ! ready to go back into the car now !
welded crossmember.png
Re: Datto_610's 180B Currently going back together
Posted: Thu Feb 14, 2013 7:06 pm
by Datto_610
Excellent!
Sent from my GT-I9300 using Tapatalk 2
Re: Datto_610's 180B Currently going back together
Posted: Fri Feb 15, 2013 6:35 pm
by Godzilladat
Can you zinc plate something that big Greg?
Re: Datto_610's 180B Currently going back together
Posted: Fri Feb 15, 2013 6:55 pm
by Datto_610
That's what she said!! Hahaha but in all seriousness yes I can.
Re: Datto_610's 180B Currently going back together
Posted: Fri Feb 15, 2013 7:10 pm
by torqued
Can you zinc coat an entire wheel?
Sent from my GT-I9100 using Tapatalk 2
Re: Datto_610's 180B Currently going back together
Posted: Sat Feb 16, 2013 8:11 am
by Datto_610
Ummmmmmm, possibly??? It would neeed to be steel but would be a pain to get right as I would have to turn it round part way through plating as there would be airlocks and it wont plate there. Maybe a start up a thread in the tech section where I can answer Zinc questions?