New Zealand Datsun Club

Andy's (With the blue sunny) mate karl might have one.

already got a few bits off him , he just didnt have the guard

been a while since i updated, as most of you have seen i have the 13x7 and 13x8 steels painted black on it now with 185/60 toyo proxes stretched on looks quite sweet, me and brendan have done the side exit exhaust poking out just behind rear left wheel, sounds quite good with the resonator (thanks brendan) and the coby, have all round headlight conversion parts just need to get painted and fitted

will add pics later

sweet man. you coming on the cruise next weekend?

yea mate, looking forward to it

so I had today and yesterday off work so after still buzzing from a wicked weekend the motivation levels where high so thought id do something as have been very slack on progress




It's just in a white primer at this stage (hence the two tone) and still not 100% finished as i need to make some tabs on inner guard for headlight springs to mount, and slot the holes in bumper brackets to move it back a little as it sticks out a fair bit. also the bottom lip won't line up with round headlight guards so looking into a solution for that,and there is a large-ish gap beetween grill and guard, that aside it went reasonably well and looking forward to getting it finished and paint matched.

Man that looks mint steve!
Its so much better, i cant wait to do this to mine

I might have a spare RHL front bumper, unless I gave it away already. (I gave it away once, but it came back again) I don't recall if I still have it or not though. I'll have to go have a look.

Bart, you gave it to me a few months back but i never collected it..I dont actually need one anyway...

Love the conversion steve, i would have thought it was a direct swap-over, bit gay its not so straight forward. Let me know if you need any measurements or pictures?