Page 5 of 11
Re: Otodats President
Posted: Wed Apr 03, 2019 3:31 pm
by Otodat
Oh hey fletch, yeah time will fly by. Which one are you getting ready for the voyage?
Re: Otodats President
Posted: Sun Apr 07, 2019 12:30 am
by fletch
260c wagon. Currently legal, but I'm trying to build an injected motor for it.
I'll do an update soon.
Re: Otodats President
Posted: Sun Apr 07, 2019 2:37 pm
by Otodat
Awesome, that wagon is so cool!
Re: Otodats President
Posted: Sun Apr 07, 2019 2:45 pm
by Otodat
This weekends efforts have been cleaning up and treating surface rust on the inside of the guards and modifying the front centre support bracket to take the horns. Started cleaning up the inside of the nosecone but it’s a bit worse than I initially thought and ran out of energy for it
Need to get some injector seals sorted for this, outfit I got the injectors from reckon they don’t do them-even though their trademe listings show them. Be keen to get them online if anyone has a recommendation
Re: Otodats President
Posted: Wed Apr 10, 2019 6:48 pm
by Otodat
Guess this kit
https://www.trademe.co.nz/trade-me-moto ... 699180.htm Should give me the seals, ex aus though.
Re: Otodats President
Posted: Thu Apr 11, 2019 12:31 pm
by gingofthesouth
I'm pretty sure NZEFI would be able to sell you a set of injector seals mate.
Re: Otodats President
Posted: Fri Apr 12, 2019 8:00 pm
by Otodat
NZEFI - we keep 6 in stock, if you need more we have to order them from overseas, will take a couple of weeks.
Seems about par for the course on this thing
Re: Otodats President
Posted: Sat Apr 13, 2019 4:30 pm
by Otodat
Put a battery in this today and it didn’t explode into a plume of smoke, weird!
Re: Otodats President
Posted: Mon Apr 22, 2019 5:25 pm
by Otodat
Have finished off de-rusting the inside of the front panel for this and given it and the front guards a soaking of fisholene, rotating a few times to let it get into the cracks
Wired in the new injector plugs
Replaced hoses on the fuel rails, got the injector hoses trimmed so everything fits
Gave things a test fit, still waiting on two sets of injector seals to turn up.
Started thinking about how I can hid all this garbage with an engine cover.
Which is going to be tricky. Mark 1 is heading for the bin as it’s not going to clear some idle valves and the bonnet. But still I think it’s doable and will clean up the engine bay heaps
Re: Otodats President
Posted: Sun May 12, 2019 7:13 pm
by Otodat
Haven’t done too much on this lately. Injector seals turned up so they are all in and screwed down. Water pump has been rebuilt and is back in. Next up I think will be sorting out coolant hoses and pressure test fuel lines for leaks. Might actually run again in a month or so.