...................................

Post by **Bartman** » Wed Dec 08, 2010 7:32 pm

Thats the easiest part of the conversion! It only takes two or three wires to make a dato engine run.

Dattochriswagon · Post by **Dattochriswagon** » Mon Dec 13, 2010 9:13 pm

................

Dattochriswagon · Post by **Dattochriswagon** » Mon Dec 20, 2010 5:52 pm

.......................

Post by **Mikewazowski** » Mon Dec 20, 2010 8:51 pm

Yes. Hell Yes!

Cannot wait to see this badboy driving around/doing a skid.

Dattochriswagon · Post by **Dattochriswagon** » Tue Dec 21, 2010 3:26 pm

........................

Dattochriswagon · Post by **Dattochriswagon** » Wed Dec 22, 2010 3:01 pm

...............................

Post by **gingofthesouth** » Wed Dec 22, 2010 3:50 pm

Looking good. Love those shaped cabs! Low is pro haha

cheese910 · Post by **cheese910** » Wed Dec 22, 2010 8:25 pm

don't raise it
cut the bumpstops in half instead.

Post by **gingofthesouth** » Wed Dec 22, 2010 9:11 pm

cheese910 wrote:don't raise it
cut the bumpstops in half instead.

Lol, what he said!

Dattochriswagon · Post by **Dattochriswagon** » Wed Dec 22, 2010 9:36 pm

...............................

New Zealand Datsun Club