New Zealand Datsun Club

thanks to all who voted on facebook wrc comp only 24hr left and still 50 likes behind so if u havnt yet do and share as well

got my like

Thanks dude only 17 behind now

kobyn wrote:Thanks dude only 17 behind now

13 now

Small update got my new 5puk clutch and presure plate also had to get gearbox output shaft machined down and a custom gearbox mount made
Driveshaft yoke done and balanced
Just have to put oil in box and run the clutch in was told that it takes 700km? Also put mudflaps on the rear

Some betta pics while up on lifter

just scored my mates 13b bp motor come outta his 1200 ute along with all the extras like mounts,raidator,holly fuel pump exshst system and 48mm IDA and electronic dizzy . Will pull current engine out in a few weeks need to get wof while the street smart rotary is still in ,posted a vid below of car with current engine and some pic of the 144 kw 13b bp thats going in

http://youtu.be/LSDcRT_BV08" onclick="window.open(this.href);return false;

so sweet

That'll be quite a handfull!
Will existing exhuast be the right length for the PP engine? I was lead to belive that ported motors were really fussy about the length of the pipes?

Bartman wrote:That'll be quite a handfull!
Will existing exhuast be the right length for the PP engine? I was lead to belive that ported motors were really fussy about the length of the pipes?

I will be using the exhaust that came with motor cos motor is dyno to that. As I understand the longer u can keep two pipes b4 going to one the betta . I should really do some research on that tho .


Sent from my iPhone using Tapatalk