have had a new under dash and engine bay loom put in to replace the mickey mouse setup it had causing intermittent electrical cutouts to the ignition. brendan did this because im not to be trusted with hot solder toys, also wired back in headunit last weekend.
Replaced with all new goodies like coil, plugs, leads, ballast resistor, codensor, dizzy cap and rotor. all that jazz.
have just sorted out some seats and doorcards to glam it up a bit
bought new tailgate and latches a while back but will wait till respray next year ish to fit up.
got rear wheels polished by aiden @ pine engineering and thoroughly recommend him and his work! still need fronts done
have some sound deadener awaiting fitment then will buy new moulded carpet kit from autodec along with underlay stuff to dull that a12 drone
Took this thing for a 1000km road trip to the coast then up to picton/blenhiem etc, didnt use and water or oil......which seems suspicious to me as she was a little smokey in mornings....but oh well, it worked!
changed out all fluids/ wired up other speaker the weekend before just incase i fucked anything up, but luckily i didnt!
ran better and better the whole drive, plus a 5spd makes a world of difference! took a few pics, and by few i mean 3, apologies for the front rims not being polished yet, its on the list!
mine and gemmas lower backs are yet to recover
it is getting a bit rusty in a few places so once the triumph and mini are going again (this weekend i hope) i do plan to get wal to look into it once funds allow, rear archs and under the windscreen are probably the worst spots yet, plus a hole in the rear wall that goes out to the tray, minor shit .......... said i about a certain other datsun some years ago.
