Page 7 of 8
Re: MR1200s 1200ute
Posted: Tue Jul 06, 2010 9:04 pm
by dirtyleppa
agree with adam, leave them as is.
wheels look epic. better than paying stupid money for someone else to do them. i might have to look into this tooo
Re: MR1200s 1200ute
Posted: Tue Jul 06, 2010 9:13 pm
by MR1200
do it ya just gota take your time and cut straight and make sure they spin true its cost me 14 bucks so far but thats only for 2 of them
Re: MR1200s 1200ute
Posted: Tue Jul 06, 2010 10:07 pm
by dirtyleppa
still, a bit of patience and some cutting discs is a lot cheaper that someone else doing them. did you check them for run out on a lathe or tyre machine?
Re: MR1200s 1200ute
Posted: Wed Jul 07, 2010 6:42 am
by MR1200
just a tyre balancer bud
Re: MR1200s 1200ute
Posted: Thu Jul 08, 2010 11:04 am
by Josh
Yeah Steelies!
Re: MR1200s 1200ute
Posted: Fri Jul 16, 2010 9:16 pm
by MR1200
not a bad lookin shed!!!
Re: MR1200s 1200ute
Posted: Fri Jul 16, 2010 9:29 pm
by dirtyleppa
twice as goood with 2 utes
Re: MR1200s 1200ute
Posted: Thu Sep 16, 2010 1:07 am
by dattosan
wowww nice mods .. thats was my dream engine lol.. r u using ga16de or ga16ds ??
whats r the mods need to be done ??
sry my english r not so good ..duh..
Re: MR1200s 1200ute
Posted: Thu Sep 16, 2010 7:45 pm
by z181200
Paint the entire steel gloss black you can get some mean sparkly gloss blacks in cans. They will look pretty ruggard all rusty. Its not a rat rod. And its not dented enough to be motorfix
Re: MR1200s 1200ute
Posted: Thu Sep 16, 2010 8:18 pm
by MR1200
yea havnt painted em yet cut them up again and made 10s. im just using them as templates so i can get the right offsets and sizes that way there will b no confusion wen i get my custom ones made
dattosan wrote:wowww nice mods .. thats was my dream engine lol.. r u using ga16de or ga16ds ??
whats r the mods need to be done ??
sry my english r not so good ..duh..
and heaps of little ones the main ones are the gearbox holes lining up and making a fly wheel but there to many to list