Page 66 of 92
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Sun Jan 04, 2015 11:40 am
by JDMinprogress
love Apaches have you thought of getting your wheels widened? places like pine engineering do it could widen them to 8.5 chuck em on the back and put the 7s up front
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Sun Jan 04, 2015 4:58 pm
by luke
would like to widen them. bid to 65,000yen on a pair of 13x7 0 offset in japan but thats getting pricey. not fussed atm really.
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Thu Jan 08, 2015 6:30 am
by luke
callipers rebuilt last night and all painted and shit, just gotta buy new pads etc, anyone reccomend anywhere decent to buy them?
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Thu Jan 08, 2015 7:13 am
by tlssunny
BUY SOME BENDIX HEAVY DUTY OR ULTIMATES!!!!!!!!!!!!!!!!!
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Thu Jan 08, 2015 9:52 am
by Bartman
Caps lock thursday!
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Thu Jan 08, 2015 2:52 pm
by gingofthesouth
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Thu Jan 08, 2015 3:41 pm
by tlssunny
ARG I KNOW, IT ALWAYS HAPPENS WHEN I LOGIN BECAUSE I HAVE THE SET PASSWORD AND THEN I WRITE A BIG LONG SPEEL AND WHOOPS IT HAPPENS AGAIN
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Thu Jan 08, 2015 3:43 pm
by broke
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Fri Jan 09, 2015 12:04 am
by mint16
Get Bendix pads from BNT or where ever.
Re: Luke's GA16DE Coupe...... SLAMMED AT LAST
Posted: Wed Jan 14, 2015 10:15 pm
by luke
Just back inside from actually working on this thing. Sound deadener all under rear seat and have started on the wheel arches and rear quarter panels. Gonna have to buy more of the stuff I suspect to complete the car. But itl be worth it, I did auckland to chch in it and good god, the noise! Also have like 6 layers of underseal everywhere so it should be all good. I hope.
Depending on income will buy some nice new brake pads this weekend and big in the whole test fit with rims etc, grind a bit... test again. ....grind a bit more.
Also on a sad note my bored out stroker motor idea is canned. Not enough material between cylinders lower down in the block.
So now........ (eventually after the car is finished)......
QG18DE Block with a GA16DE Head ported/honed etc to suit the new piston size. Yet to figure out the right gbox. Will try locate a rwd ga16 one, but omfg so hard to find. Chasing a guy up north at a wreckers currently.