Page 1 of 1

Shifting.

Posted: Tue Jun 08, 2010 2:53 am
by torqued
Ever since i got my car the placement of where the motor sits has always given me nightmares.
And lately the more i think about it the more it gives me the shits.

So in the aid of handling ive been tossing up the idea of bringing it well back into the fire wall, This is the easy part.
From what i measure the only issues i may have are wiper mechanism , draglink and relocation of the brake lines that cross over the tunnel. all easy fix.

But im more worried about gearbox shifter location because as the box comes back so will it.

I have a idea of the contraption i may have to make up to keep this in a usable place but wondering if there is a easier idea out there

So to put it out there any thoughts and ideas on the shifter side.

Re: Shifting.

Posted: Tue Jun 08, 2010 5:52 pm
by slo_dat
You could use the shorter Skyline L-series gearbox with your bellhousing to get a better shifter location, otherwise fabricate a remote shifter, using a ball joint as it's base.

Re: Shifting.

Posted: Tue Jun 08, 2010 8:31 pm
by datsunboy
cheapest way is just to make some ugly as bent shifter deal...

BEST way.....is be an awesome fabricator like this guy.....half way down the page shows what he did to a shifter to make it work.
http://www.67-72chevytrucks.com/vboard/ ... 26&page=20" onclick="window.open(this.href);return false;

(someone else posted that build thread somewhere else on here)

Re: Shifting.

Posted: Tue Jun 08, 2010 9:11 pm
by fast4motion
Just slide your seat further back. And cable tie some blocks to the pedals if your legs are too short.

Re: Shifting.

Posted: Tue Jun 08, 2010 10:19 pm
by torqued
fast4motion wrote:Just slide your seat further back. And cable tie some blocks to the pedals if your legs are too short.
ROFL.
datsunboy wrote:cheapest way is just to make some ugly as bent shifter deal...

BEST way.....is be an awesome fabricator like this guy.....half way down the page shows what he did to a shifter to make it work.
http://www.67-72chevytrucks.com/vboard/ ... 26&page=20" onclick="window.open(this.href);return false;

(someone else posted that build thread somewhere else on here)
thats what i was thinking. Well slightly more a pivot ball system

Old mans a engineer so the fabrication part doesnt worry me.
Just gotta make him do a brendan/brock and move to chch

Re: Shifting.

Posted: Wed Jun 09, 2010 12:39 am
by slo_dat
Haha this :
Image

Or these :
Image

Re: Shifting.

Posted: Wed Jun 09, 2010 8:06 am
by torqued
That short throw idea was what i was thinking.

Keep you posted on the happenings

Re: Shifting.

Posted: Wed Jun 09, 2010 10:14 am
by Phatsun
Put it in the boot yo! rear mount VG FTW!!!