New Zealand Datsun Club

Is anyone interested in a 200B wagon, or parts from it?

An old guy saw my B310 wagon, and said he had one in a paddock if I was interested in it. Luckily he showed me a photo before I went to pick it up, as it turns out it's a 200B, not a B310.

Apparently it's badly rusted, one of the front hubs is damaged, and it hasn't run for a few years. But it was driven to its current resting place, so the motor etc should be salvageable. And it's an automatic.

Are the front rotors salvagable?
I'm told (by a bloke at 1200.com) that 200B rotors fit B310 hubs and work with VL calipers using a thin sapcer.

I haven't had a look at it, so I'm not sure what condition everything's in.
It's probably about an hours drive away, so I'm not interested unless people want enough parts to make it worth my time.

200b will most likely be solid disc, my 200b wagon was solid as well as a sedan i fleeced parts off a long time ago.

would they be worth the hassle?

I doubt there'd be any parts I want.
Do you know what type of diff would be in it? And what ratio, considering it's an auto?

h165 4.11 solid axle rear end.