New Zealand Datsun Club

ok so as it says i need to make up my plates for my seat so looking for some 3mm steel plate 100*100 and 8 so i can cut them my self but thats about how much i need

and prefer in chch?

thanks lee
pm if you can help

you might have more luck asking in an engineering shop

hey man, what do u mean by 8, is that the grade of steel you want or what.

will get hold of a mate and see if i can organise something, or maybe even just a rough price for ya

oh sorry dude i mean i need 8 of them or about that much

Hi I'll try again not sure you got my last post , but i have 3 mm plate and plasma cutter and mig

my mate can only do it in a 150 x 150 mm size. any good?

Hey guys thanks for all the ideas and big thanks to glen aka 1600jsss for welding my seat its always good to meet new datto fans too

thanks again