New Zealand Datsun Club

Another member has told me to start a project thread. so i'll put a few pics up of what i can dig out for now.
There are a few photos missing from the middle part b4 paint but there around some where this is all i could find for now.
I'll put up some specs of what mods i have done to the engine when i find my book of it all but yea take alook and let me know what ya think.

Also i am trying find a rubber kit 4 the hole car but not so lucky in finding one of yet so please so let me know if ya know where one is or can get one thanks!

sweet dude. very nice.

its almost to pretty to drive

should be able to get a full rubber kit from scottsoldautorubber or spectrum rubber in aussie

Ahaha yea thanks yea i told the mrs it just going stay in the garage whens it's done i wont wana get it dirty. i'v painted the hood and tail gate and front guards but i cant find any photos of them at the moment.

I did ask about it in ozzy but they said they neva had this model in oz so i left it at that? but thanks i'll have alook cheers.

Awesome to see another 2dr 1200 wagon dude.!!
I gotta lot of love for these!

Hey i'v looked at both them sites that u said to have alook at but still hard to understand coz all it will say is 1200 sed/wag/coupe and the wagon one is good till i hit the back seat windows coz there not the same as the 4door wagon windows? and my wagon is a wagon but it's a 1200 coupe so. so i am a bit lost coz my car is a coupe wagon? i'll leave a photo of the window i mean.

maybe try looking for the bits you need under a 2 door 1200 wagon. i think referring to it as a coupe wagon may be confusing the matter. the coupe and wagon are 2 completely different body styles

Ohh ok i'll try look around bit more yea it really does. but the only reason i say that because the reg says 1973 1200 coupe? but thanks i'll have alook.

i wouldnt take the rego sticker for gospel, my previous car was a laurel, and it was regd as a larel. when i wanted to change it, that told me i would have to reregister car if i wanted it done correctly