New Zealand Datsun Club

Hey i currently have a pair of 5x1 stud pattern input shafts for a R200 VLSD but i need the 3x2 pattern ones for my project, have already got my cv axles greased and assembled so dont want to just change them all to 5x1, can do a swap or just buy some im not too worried. In chch would be preferred but understand it might be difficult at the moment no rush either. Must be for a Viscous LSD so one shaft should be longer than the other. Cheers.

Bump heres a better idea of what im after minus the LSD center.

would you like me to try at silviaNZ greg?

Already have and they are telling me that 3x2 ones wont fit?????

Would you like to bring your LSD center over and try one of my 3x2 inputs in it?

Yeah dude sounds good, quite keen to prove these guys wrong.

Weird i thought that they were interchangeable.

I fitted 3X2 non lsd inputs into an R31 open center, which had originally used those intergrated input cvs.

I honestly thought that the only difference between the 2x3 and the 5x1 was the Hole location.
Id be very interested if someone could try this and prove otherwise.

We'll know for sure when we try gregs in my diff.