New Zealand Datsun Club

right i have too much crap laying around sooo
tailights off 910 bluebird nz new model

shit $30 for both
indicators for 910 , one has the protruding bit in the middle and the other flat $20 for both

set of generic roof racks can see pics of them sitting on wagon in my project thread
$50
mis bit and bobs for 910 center console blanking thingie window arms etc
$5 each or somthing
chrome trim from 910 sedan was saving for hardtop but i decided not to
$20 for lot
shims for r180 or r160 diff
$20
truck airhorn extremly loud was a bit worn so i have a fix up , has signs of use etc
$20
pretty much brand new vgt garret turbo

open to offers as this turbo wont be suited to much
s12 gearbox from the hardtop. not gonna lie has seen a few clutch dumps. split it while 910 was gathering dust out back and saw nothing wrong with it , bearing noise in 3rd.
$150
custom made lowering blocks by hemi engineering + ubolts to suit for 910 wagon but would fit most stz
$60
oil pump (split checked and reassembled) , afm and cam angle sensor (x2) say $15 each

heater core for 910 bluebird , random i know but i remember mine shitting out and i had a mission finding one , so here it is
$20
dash cluster for 910 , has rev counter and digital clock even!!
$30
misc rod and girdle etc for ca18det
. pm me
r180 vlsd + halfshafts 3.7:1
$200
s13 gearbox even come with this awesome escort cable bracket that i swear is made out of an old nuclear bunker
$200
2 stroke deathmachine , electric start still works , pretty rough would be good for someone who can tune it and get it running right again
offers
and a ca18det longblock
offers
also have seedies 910 coilovers for the front which i decided will not be going back into the hardtop soo pm me etc

i also have a sss grille for 910 with a silver 50th anniversary badge

keen on the tail lamps , the ones on the crusty 910 I have dont match...

If the person on TM I'm meant to be getting lowering blocks off doesn't get back to me by next week I'll be keen for the blocks and U bolts.

sweet chaps just slam me a pm when you do i tend to forget to check things otherwise .
kitch sweet dude wanting about $20 for them i think i siad? . again pm me etc .
mike sweeet dude , just as a side note they are 3" and they slam the bejesus out of wagon

How much for the 50th anniversary badge... txt me 0276030303

What was the turbo fitted to originally? You say it wont be suited to much. Too big, or too small? Or off some stud arse diseasel engine?

Bartman wrote:What was the turbo fitted to originally? You say it wont be suited to much. Too big, or too small? Or off some stud arse diseasel engine?

bingo on the last one mang , came out in vw merc and audi vans . this particular one came out of a pinzgaur. those 6 wheeled apc type things the army use , size of a large van etc .

so what was the displacement, boost range, and rpm range of the engine it came off? Would it go any good on a hemi Hemi?

came of a 2.7 or somthing like that? . its tiny man would prob suit a 1300 or similar if someone wanted to sort the vgt curve out .
a hemi? holy shit no would barely run one cylinder haha

Sounds like a paper weight/doorstop then.