New Zealand Datsun Club

Make an offer on most open to NZdatsun members before I put it on trademe
Bonnet vent/sFront x Rear x length x depth of dip
526mm x 870mm x 673mm (each dip is 220mm wide by 60mm deep) I do have side vents as a set but I cant find the primered pretty 1's to advertise a set

Evo airbox

S13 centre console / Hand brake

Mazda Capella wagon tail lights
has bulbs

Eunos 500 tail lights

Eunos 500 indicators

FJ holden heater box
Im told it has a reconditioned core $80

Boot spoiler make unknowen
has high stop light unused Boot spoiler top side 1260mm underside 1153mm


Small bonnet vents (or guard if they fit)Made these a little thick, 4.5mm think (thicker than what I make them) dips are 120mm wide by 40mm deep, Length widest 270mm x 265mm

hey do you reckon that S13 handbrake etc would work in an A31?

not a clue...its off set to the right slightly. Alot of mucking around if your A31 handbrake isnt in the same spot

My shitfiro has a foot operated handbrake. IFAIK, the A31 and S13 are so similar, theyre like cousins who are also brother and sister

Soooooooooo...if they're inbred...maybe it'll work then?

Bartman wrote:My shitfiro has a foot operated handbrake. IFAIK, the A31 and S13 are so similar, theyre like cousins who are also brother and sister

gee that sounds like an episode of 'the simpsons'