Page 1 of 1
Copper washers for turbo banjo bolts.
Posted: Sun Jun 12, 2011 2:12 pm
by Datto_610
Anyone know where to get the copper washers that go on the banjo bolts for turbo oil lines??? I need 6 and cant find any at repco etc as they only sell a few sizes which arn't the ones i need. Dimensions are O.D 20mm and is I.D 15mm roughly. Any help much appreciated.
Re: Copper washers for turbo banjo bolts.
Posted: Sun Jun 12, 2011 2:48 pm
by 85_Z31
Datto_610 wrote:Anyone know where to get the copper washers that go on the banjo bolts for turbo oil lines??? I need 6 and cant find any at repco etc as they only sell a few sizes which arn't the ones i need. Dimensions are O.D 20mm and is I.D 15mm roughly. Any help much appreciated.
they are the same type of copper crush washers as used in power steering hard lines, You could try gettign them directly from nissan, or A hydrualics place
I think Steve ( datman310) works for Hydralink give him a pm perhaps
Re: Copper washers for turbo banjo bolts.
Posted: Sun Jun 12, 2011 3:36 pm
by skdmrx
Hydrolic seals/fittings places or safe-r-brakes have em
Re: Copper washers for turbo banjo bolts.
Posted: Sun Jun 12, 2011 3:57 pm
by Datto_610
Cheers guys, i'll look into those options.
Re: Copper washers for turbo banjo bolts.
Posted: Sun Jun 12, 2011 4:35 pm
by DAT620
blacks fasteners, wilson brothers, saeco, steel and tube?
Re: Copper washers for turbo banjo bolts.
Posted: Sun Jun 12, 2011 4:44 pm
by nick_m
yeah cv specialists have them too but safe r brakes are cheaper.
Re: Copper washers for turbo banjo bolts.
Posted: Sun Jun 12, 2011 4:59 pm
by Datto_610
Sweet ill pop by safe r brakes after work tomorrow.