Page 1 of 1
wanted R31 rear rotors
Posted: Thu Jun 16, 2011 8:12 pm
by nick_m
as above after a set of r31 rear rotors
Re: wanted R31 rear rotors
Posted: Fri Jun 17, 2011 5:36 pm
by Datto_610
Do they need to be mint?? As i have a pair of old ones you can have, was gonna get new ones when i get everything sorted for the rear end.
Re: wanted R31 rear rotors
Posted: Fri Jun 17, 2011 7:05 pm
by nick_m
sweet dude i'll check them out when i'm round next
Re: wanted R31 rear rotors
Posted: Sun Jun 19, 2011 11:00 am
by 85_Z31
I'm not sure if Z31 Rear rotors are the same but i will have an unwanted set of those sometime soon as Im going vented rear on my 300zx, possibly a set of calipers to suit the rotors up for grabs too.
Re: wanted R31 rear rotors
Posted: Sun Jun 19, 2011 5:22 pm
by nick_m
r31 rear rotors are 260 diameter 10mm thick 60mm deep (in cross section) and 4 X114.3 according to DBA catalog
The 60mm is the main bit i'm after as most nissan rotors are only about 45 deep which is about 10mm too shallow for a 2 or 4 pot caliper!