New Zealand Datsun Club

ok what i know is that gtr skylines had the 6x1 inner flanges with 30 spline what i am trying to do is graft this 30 spline diff into my datto but the diameter off the 6x1 is to big so what im trying to find out is there any off the 5x1 inner flanges with 30 spline whether it comes from a skyline a silvia or 300z or anything else any help apreciated here ...........update and or Q45

There's some on Trademe pretty cheap

http://www.trademe.co.nz/motors/car-par ... 067175.htm

cheers yeah spotted those but theres another type im after that are a round flange not the 6x1 pattern

i have seen these but they have different number off bolt holes but am still curious off measurements
http://www.trademe.co.nz/motors/car-par ... 293857.htm" onclick="window.open(this.href);return false;
http://www.trademe.co.nz/motors/car-par ... 067174.htm" onclick="window.open(this.href);return false;

I'm fairly sure that most silvia LSDs were 5x1.

Bartman wrote:I'm fairly sure that most silvia LSDs were 5x1.

i would be keen to find out the spline count off the inner flanges

The splines that go into the diff? They are the same as the usual long nose axles, 29 I think it is?

DJZ wrote:The splines that go into the diff? They are the same as the usual long nose axles, 29 I think it is?

swt yea this is what i am finding .........i have made an update at the top off first page .........

All I can find is that some models of Q45 may have had 30 spline 5x1 flanges, they'd be reasonably hard to come by here.

DJZ wrote:All I can find is that some models of Q45 may have had 30 spline 5x1 flanges, they'd be reasonably hard to come by here.

swt there maybe a glimmer off hope yet ......any body got Q45 inner cvs