Page 1 of 1
Injector seals and holders
Posted: Thu Sep 01, 2011 9:34 pm
by DJZ
I'm after a couple of injector "seals" - the big rubber piece around the middle of the injector and a couple of the plastic hold down clamps as fitted to RB20DET red top engines, RB30E engines and maybe some RB20E and other Nissan motors.
The plastic holder as shown in the picture, the rubber "seal" sits underneath this, most Nissan motors with top feed injectors have these rubber bits, L28s and RB2xs do.
Re: Injector seals and holders
Posted: Thu Sep 01, 2011 9:56 pm
by dirtyleppa
i would go speak to diesel services ltd. they have heaps of parts for injectors and what not. or maybe try cockram nissan
Re: Injector seals and holders
Posted: Thu Sep 01, 2011 10:05 pm
by DJZ
Lets just say I'm looking for a more cost effective option
Re: Injector seals and holders
Posted: Thu Sep 01, 2011 10:11 pm
by dirtyleppa
fair enough. so you are after the o-rings and spring steel clips that go on the plugs to the injectors?
Re: Injector seals and holders
Posted: Thu Sep 01, 2011 10:37 pm
by DJZ
Sorry, my wording is terrible. I need three of the plastic holders around the middle, they are held on by a circlip and bolt to the manifold.
Underneath that holder is a big rubber thing, I think it's just a vibration isolator or similar, it's not actually a seal, it's flat on the sides.