New Zealand Datsun Club

For sale I have the following

Z31 Front Hubs 5 Stud $100


Z31 Front brake setup, Calipers complete with new pads and rotors that were machined and only did a 2000kms before I upgraded $70


Z31 Front strut Tubes, inc spring, spring retained and bearing isolator strut mount thingy
These are 55mm outside diameter but they do have the 100mm bolt spacing. $150

Note: Picture is not of actual strut, but mine are old and dirty & leaking just like the picture so yeah.

S13 Cusco Camber plates , I was going to rebuild and modify these to suit my car, they are sloppy in the bearings, the bolts are mostly stuck and the anodizing is pretty rough. Poor Condition want them gone $50
or the first person to buy something gets them thrown in for free.



Z31 Rear brake rotors & Pad holder brackets., 290mm 10mm wide SOLID, these are a bit scored but a machine would bring them back up to good condition. There are no Calipers or pads with this but I could help you source some calipers from the USA. $70

NOTE , picture is to show the rotor only, caliper , Pads & wheel spacing NOT included

I can deliver these parts into Christchuch for nothing as long as its a Satturday or Sunday.

Or you can take the entire lot for $250, I need to sell some of this Crap so I can buy Mint16's R200 Long nose Diff.

i could be keen on the camber plates, Pm me

Do you have both front brake shields? I see one in that picture.
You really unlucky i don't have spare money right now i know those front 5stud hubs would be good to have as spares for something.

unlimitedpower wrote:Do you have both front brake shields? I see one in that picture.
You really unlucky i don't have spare money right now i know those front 5stud hubs would be good to have as spares for something.

I can have a look to see if I have the Brake Shields, they might be bent because I had 2 sets and used the best ones on my car.

Deano Will pm you when im back from work