Resistance of injectors and resistor packs
Posted: Wed Nov 02, 2011 9:31 pm
Now my understanding of injectors is
Low impedance = 2-3ohms
High Impedance = 12-13ohms.
The CA18DE injectors i have now measure 13.7ohms
I plan on swapping to some larger low impedance injectors either CA18DET or Evo 1-3 injectors as they are cheap.
Now i'll need to run a resistor pack and i have one all ready to go. Its from a L18E it measures 6.7ohms
Nows heres what im worried about if the low impedance injectors are say 3ohms and my resistor pack is 6.7ohms wouldn't this mean that basically each circuit is 9.7ohms. Much lower than a high impedance injector. Is this likely to cause an insure and overheat my injector drivers.
Are all resistor packs basically the same or are there ones with different resistance levels?
Any advice much appreciated.
Brett
Low impedance = 2-3ohms
High Impedance = 12-13ohms.
The CA18DE injectors i have now measure 13.7ohms
I plan on swapping to some larger low impedance injectors either CA18DET or Evo 1-3 injectors as they are cheap.
Now i'll need to run a resistor pack and i have one all ready to go. Its from a L18E it measures 6.7ohms
Nows heres what im worried about if the low impedance injectors are say 3ohms and my resistor pack is 6.7ohms wouldn't this mean that basically each circuit is 9.7ohms. Much lower than a high impedance injector. Is this likely to cause an insure and overheat my injector drivers.
Are all resistor packs basically the same or are there ones with different resistance levels?
Any advice much appreciated.
Brett