New Zealand Datsun Club

hey just woundering if anyone on here would have a sr20det power steering pump bracket? apparently the sr20det bracket is different to a sr20de? i know you guys wouldnt need it in for your conversions so thought there might be couple lying around.

Thanks Dale

Never heard that before. Dont see it would be

If you find they are the same as the de ones let me know as I have one of them lying around.

RWD or FWD?

RWD are the same, I know as I have both sitting in my garage.

spiderwebfx wrote:RWD or FWD?

RWD are the same, I know as I have both sitting in my garage.

The spare I have is RWD so let me know if you need it finchy.

ok il have to double check then, mine is rwd black top nd the pully of the power steering pump sits alot more forward than the pully on crank?
Thanks

think you are refering RB vs SR which is the case.
But can be modded to fit with a few washers.

The pulley on the crank should have three sets of ribs for the alternator belt, air conditioning belt and power steering belt. The forward most one is the one used for the power steering.

Did anything SR powered come fitted with hicas?
I found that the hicas equiped powersteer pulleys were different.

Yes. Some S14's had hicas. I can't tell you anything about the differences on it though. I think the pump is completely different to a non-hicas one so this could be why it doesn't match up.

If it is because the pump is from a HICAS equipped vehicle, you'll find it's probably not the bracket that is the problem, but the pump.


Quick photo comparison: Different angles but I'm not going to troll google images for better ones.

HICAS


Non-Hicas