New Zealand Datsun Club

Reply here or PM me for question or if you'd like something. All parts in Rotorua.

All parts are AS IS as a lot of it I haven't used. I have other parts that aren't listed, ask if there is something you're after. I'm not a wrecker, just trying to clear my garage.

S12 power steering rack
$40

S12 factory front lower control arms
$30

S12 FJ20ET crossmember. This is the taller type one. Currently sandblasted awaiting someone to spray it. Would recommend a good sand or sandblast again as it's getting surface rust.
$60


S12 front brake calipers and rotors - heaps of pad life left
$40

S14 factory castor rods
$20

S14 SR20DE ecu - have two, both different part numbers
$20

S15 brake booster and BM44 brake master cylinder.
$50

S15 non turbo front brake calipers and rotors.
$50

S15 interior loom includes dash loom
$50

SR20DE water neck - suit having water temp sensor thread put into it.
$10

SR20DE/T viscous fan - have two
$20

SR20DE/T alternator - unknown condition
$25

SR20DE/T power steer pump - non hicas
$25


SOLD:
S12 castor rods - pending payment/pickup
S12 castor rod brackets - pending payment/pickup
12" electric fans with alloy shroud - pending payment/pickup

Hi could you measure the crossmember for me from mount holes to mount holes (chassis) - many thanks - brock

This may work in my 1200

775mm centre to centre

-Chris

Hi chris, I'd be keen on those castor rods and bottom arms as discussed when I was over your way,
Morgan

Sweet as. They're still here so your welcome to them.

I'll have a measure up of the DR tomorrow but I might be interested in the steering rack and crossmember.

DJZ wrote:I'll have a measure up of the DR tomorrow but I might be interested in the steering rack and crossmember.

This crossmember will fit the DR. Don't know about the steering rack though (in terms of width).

Want as much of this gone as quick as I can, it's all helping for a deposit on a house.

bump

text for limit

List updated.

bumping it up