Page 1 of 2
L24 wanted - upper north island area
Posted: Wed Aug 01, 2012 9:13 pm
by mark105
Im after a L24 block to build my next engine for the 240k. As long as it is rebuild-able it will be fine as it is going off to the engine builders to be combined with my N42 head. Basicly just need a short block but will take what ever. Chur.
Re: L24 wanted - upper north island area
Posted: Thu Aug 02, 2012 1:13 am
by nzeder
You know a N42 head has large valves for the 400 extra cc. As a result of this you need to notch the top of the P30 aka L24/L26 blocks to give the valve clearances as they only have a 83mm bore vs the L28 86mm bore.
I know of a complete L24 head/block only just pulled from a going 240z here in Auckland.
Re: L24 wanted - upper north island area
Posted: Thu Aug 02, 2012 9:59 am
by mark105
yeh i know about the head differences. im going to build this into something than is more suited to the track than the road.
are you talking about mikeys 240z L24? thats now getting the V6. I have spoken with him about it and he said he might sell it but this was when he was first thinking of putting the V6 in. I must contact him again and see if he wants to part with it but last time he was some what reluctant.
Re: L24 wanted - upper north island area
Posted: Sat Aug 04, 2012 12:21 am
by nzeder
mark105 wrote:yeh i know about the head differences. im going to build this into something than is more suited to the track than the road.
are you talking about mikeys 240z L24? thats now getting the V6. I have spoken with him about it and he said he might sell it but this was when he was first thinking of putting the V6 in. I must contact him again and see if he wants to part with it but last time he was some what reluctant.
Yes I am talking about Mikey.
Re: L24 wanted - upper north island area
Posted: Sat Aug 04, 2012 9:00 am
by mark105
ive already asked Mikey. he doesnt want to sell his engine any more.
Re: L24 wanted - upper north island area
Posted: Sat Aug 04, 2012 10:13 pm
by nzeder
Will a L26 block work for you also I know of one that is available. They are the same casting aka P30
Re: L24 wanted - upper north island area
Posted: Sun Aug 05, 2012 10:41 am
by 68p510sss
I have a L20 that I am about to part out. The con rods are sold. I suspect the block may be the same as a L24, just the stroke shorter. Cheers Andrew
Re: L24 wanted - upper north island area
Posted: Sun Aug 05, 2012 6:21 pm
by mark105
The L20 has a different bore and stroke to what im after sorry and is not the same as a L24.
The L26 block would work. Would just need to obtain a L24 crank then and id be away. How much we talking and condition?
Re: L24 wanted - upper north island area
Posted: Sun Aug 05, 2012 6:31 pm
by torqued
I'll be keen on the l20 what block and head is it? What parts you got?
Sent using Tapatalk 2
Re: L24 wanted - upper north island area
Posted: Thu Aug 16, 2012 2:49 pm
by mark105
bump, still after one of these.