Page 1 of 1

removing pitman arm etc..how

Posted: Wed Aug 29, 2012 9:46 pm
by funkydato
anyone got tips on how to get the pitman arm & steering box arm off the bar that goes accross the crossmemember, I have not got a ball joint splitter.

But thought you guys out there may have a cunning way to get them off???

Cheers

Re: removing pitman arm etc..how

Posted: Wed Aug 29, 2012 10:08 pm
by classicdat
Just loosen the nut leaving it on a couple of turns, to protect the thread and stop the joint flying off. Hold a heavy hammer or other suitable hard heavy metal object on one side of the joint, (the metal that has the hole in it the shank goes through) and smack the other side of the hole. What you want to do is shock the hole out of round so the shank of the tie-rod end pops out. Hope this makes sense.
All the best. I have never used a splitter.

Re: removing pitman arm etc..how

Posted: Wed Aug 29, 2012 10:33 pm
by funkydato
I know exactly what you mean, I give it a go tomorrow. Cheers Pickles

Re: removing pitman arm etc..how

Posted: Thu Aug 30, 2012 11:30 pm
by classicdat
How did you get on?

Re: removing pitman arm etc..how

Posted: Fri Aug 31, 2012 4:57 pm
by funkydato
Mint, got them, but they were in there good.