New Zealand Datsun Club

Well I can't find one of these anywhere, or a loom! So I've gone down the megasquirt route.

What I need to know is the resistance of a wire feeding out of the resistor dropping pack / resistor pack feeding injectors on a Z18ET. That way I can just build my own. Can someone please measure one for me?

Cheers!

What impedance are the injectors? You can work out what they need to be from there. The resistors don't have to be perfect as the voltage changes so much.

Yeah I've built one for John (skdmrx ) take a look in his thread to see if he posted a pic.

Sent from my GT-I9100 using Tapatalk 2